Hi everyone, I don't know if it's a known bug or if my unit is faulty but my P3 seems to only monitors battery life if the screen is set to show info when firing. When the screen is set to stay off and I go in the Aup or Adown menu to check battery life, it gives the last reading that was shown before turning the screen off. Don't know if I'm clear...
This morning I put a fresh battery before going out, the screen was set to off since last night. Hours later I go in the Aup menu to check battery life and see 99%. More hours later still 99%... So I turn the screen on, fire and see 73%, take a few puffs and see 47%, like it has just started monitoring and is adjusting. Then I set the screen off, and an hour later it still reads 47% through the menu. I turn the screen on again and see 39%...
Firmware is version 35, production model. Brand new AW IMR batteries.
Second issue: since I got my P3 yesterday I've been using the same 3ohm Boge cartomizer, between 8 and 9W. Activating boost mode (whatever the level) gives me an error 31 (OUTPUT SETTING OR ATOMIZER OHMS TOO HIGH). The P3 fires, but I've got that warning sign on my screen. I've tried lowering watts, even down to 4W, and it doesn't change anything: activating boost mode gives that error. I've tried voltage mode as well as a different battery, same thing. Ohm reading is 3.05 and IQ is 89.
I sometimes get the second issue on both my P3's, v31 and v35. Only thing that solves it is changing coils. When the concerned coil is cleaned, it's fine again.
Sent from my iPhone using Tapatalk


