OGOGO mod!

[shpuvel]

Hello from Sasha from Russia! I present to you OGOGO modes.

This device is powered by two batteries 15270 for 6v, or single 14,500
for 3.6 v. Two options - a first for the atomizer 901(LR and regular)


and the second-bottom feedder tank capacity 4ml-510 HV atomizer.

Completely mechanical, no electrical parts except the battery. Material - aluminum, coated with titanium nitride. Protection against accidental pressing - unscrew the protective ring on the button.

The tank is made on the basis of knowledge obtained on the forum, thanks ROADRASH, and others. Tank wall are soft,made from a syringe plastic, allow the press to get the portion of liquid.Filling the tank you can do with a syringe through the top hole.

Mod was a three-month test of Russian smokers and is considered excellent.
As usual curse Google translator! I read, speak in English but writing is above my head, sorry,.

 

[utak3r]

I really like the second concept
How the liquid enters the thread, is this center post drilled on its bottom? How far is it going into the atomiser?

 

[shpuvel]

The center post is tube,have hole on its bottom.Into the atomiser it going till coil via central air hole.And it is not a concept! I have a some of concepts ... ready ...

 

[Dustydragon]

are these for sale? looks very nice!!

 

[utak3r]

And it is not a concept!

Ok, I've wrote it wrong way

Into the atomiser it going till coil via air hole.

Hm, Is it smaller than the air hole in the connector? I mean, the air should get in, too

Nice job, congratulations - it looks really well done.

 

[asdaq]

Shpuvel, this turned out really well and I would like to learn more about the switch. With regards to the tank and feeding, the squeeze is nice but also be an auto feeder if the tube is a bit higher and air can get into the tank around the tube. Great job all around.

 

[shpuvel]

The switch is "screwdriver" principle,flat contact with spring inside.About autofeeding -there is,just screw atomiser complitely and you can use it like the suckaton.

 

[asdaq]

Sweet. If it is dependable then I could recommend switching from syringe tubing to plexiglass as parts won't come apart as easily and the need to squeeze is not an issue anymore. Any chance for a pic of the switch taken apart?

edit: Sorry, I just saw closer that the syringe slides over the aluminum part with the large window cut out, I missed that before, disregard changing the tube. Not necessary. Even better design and very inspiring

 

[shpuvel]

-unsafe
- safe

 

[addisdaddy07]

frickin gorgeous... don't think there is anything more to say.

 

[gribok]

Possible to watch the process of filling the tank? Thanks.

 

[shpuvel]

Hi! This is small how to,for OGOGO mod.First -i show how to change the batteries,and after -how to refill the tank.

 

[gribok]

As I understand it, instead of 2 batteries 15270, 14500 Insert the battery. Atomizer same twist?

 

[shpuvel]

Ogogo! Your English is better than mine! Perhaps the use of two 15270 battery provides high volt atomizer and 14,500 regular or LR .

 

[gribok]

How much does this assembly? Are you from Russia? Can communicate by email?

 

[shpuvel]

Konechno,tovarishch, email you.

 

[shpuvel]

Sorry about Russian,the video show how much vapor make OGOGO.

 

[jivefly]

How can I buy one of these tanks? I would even pay for schematics.

 

[shpuvel]

jivefly, send you PM.

 

[beast775]

excellent idea.looks nice.put me down on your list!