Hello and welcome to the forum @sneebra. Glad to have you here!
The only way to change your ohms is to install a different ohm coil.
As to watts & volts, it's up to you to decide which mode you wish to run in. That decision is based on personal preference. I usually run in wattage mode.
If you raise the volts, the watts go up. If you raise the watts, the volts go up. If you change the ohm (different coil), you'll have to use a higher or lower watts or volts to get the same heat.
with watts, start low and move up; if it gets too hot, turn it down,
if you change what you put on top the istick, you will probably need to adjust up or down.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.