? on dual coil rebuildable

[ZeroSK8]

I have experience with a single coil RBA and am receiving a igo-w tomorrow.
I want to set up dual micro coils on a smok SID. I have 28 and 30 gauge kanthol and want a combined 1.5ohm's.
Looking at some info here I'm not sure if that is even possible.
I like using a 5/64" bit to wrap on. Am i going to have to do a ton of wraps to get two 3ohm coils?
I'm not sure how low ohm I can go with a smok SID?
Thanks,
Zero

 

[sawtoothscream]

it took like 14 wraps on a 5/64 drill bit for me to make a single 1.4ohm micro coil with 28ga. I would go with 30ga

 

[eda123]

I regularly get 1.5ohm dual coils with a 10 wrap on a 1/16 drill but using 32g. Doing it with 30 will need a lot more wraps...28 probably isn't feasible.


Sent from my Provari Mini using Tapatalk