one hole too many...

[sweet white mist]

I have kr808d-1 battery and cartomizers,and have problem....too much air....battery has two holes for air.DSA901 has no holes so inhaling is too hard....can I plug one hole with something to reduce amount of air when inhaling....

 

[Lisa66]

Yes..... I have done this. I heard someone say that you could take a wooden tooth pick and break off the tip in one of the holes. It didn't work that well for me. What did work for me: Take a tiny piece of tissue or paper towel and push it in the hole with a pin or needle. Good luck!

 

[Leif]

You could also use a pair of scissors and cut a strip of rubber off one of the many end-caps (condoms) you probably have laying around, and push it inside the thread connector, between the center and outer edge.

This works perfectly for me.

 

[popeye79]

I think it would just be easier to use a small piece of tape, or cover a hole with your finger.

 

[Archer]

I've used tape, quick and simple.

 

[earthpig]

tape works. So does cutting a piece of condom off and slipping it over the battery/carto and move it to where needed.

 

[radiated1]

Dental floss on picks works great and lasts forever. Clip a tiny part of plastic Handle part then push in the hole. Twist until it breaks off in there. Works like a charm. There is a video somewhere on v4l fourms showing how to do this. Also same video shows how to adjust post if carto for tighter draw also. Good luck.

 

[sweet white mist]

Does it have to be done with new batterys?

 

[radiated1]

No. You can do it any Time.

 

[sweet white mist]

No. You can do it any Time.

I did not get it.......does it have to be done with new ones?

 

[radiated1]

No. Works on old batteries also.

 

[PapaJoe8]

Old Texas rule... if Duck Tape won't fix it....... throw it away!!!!! ))
Joe