Penelope vapor production

[s1mp3]

Sent from my thumb

 

[Bishopheals]

S1mp3 Can we say Finally your vaping

 

[s1mp3]

S1mp3 Can we say Finally your vaping

Yes we can, my friend
Thank you all for your help!

Sent from my thumb

 

[imeothanasis]

the 3,5 mm wick will make you feel much better with your penelope s1

Yes we can, my friend
Thank you all for your help!

Sent from my thumb

 

[s1mp3]

Thank's for the tip, Imeo, I"ll try it as soon as I use this 8m of 3mm that I have

Sent from my thumb

 

[blackwater]

Double up your channel wick.

 

[s1mp3]

Double up your channel wick.

Wouldn't that be too thick for channels size?
I'm using double wick, but only one of them i feed down the channels.

Sent from my thumb

 

[Beco]

So, did your vapor production get better?
What did you change in setup?

 

[s1mp3]

Right now I'm using double wick, with 0.20 NiCr (1.3 Ohm). I have closed coils around wick. Wrapped coils without pin.

Sent from my thumb

 

[imeothanasis]

if your wire is so fat (0,2mm), make a coil at 1 ohm S1.

Right now I'm using double wick, with 0.20 NiCr (1.3 Ohm). I have closed coils around wick. Wrapped coils without pin.

Sent from my thumb

 

[Beco]

I'm using 0,16 nichrome because I like it to have faster heating reaction.
2.1 ohm 4.2V, that's about 8 Watts
It's vaping great.

I tried 0,20 and I don't like it. It is to slow

 

[s1mp3]

if your wire is so fat (0,2mm), make a coil at 1 ohm S1.

Hi Imeo, I'm using Pen on my Provari so I think 1 Ohm coil could be a problem.
Next time I'm recoiling her I'll do coils as you suggested a few posts back (0.15 NiCr).

Sent from my thumb

 

[imeothanasis]

ah, ok then S1

 

[blackwater]

Imeos wires give me much better vapor. Not sure why but they do.