Where would one find that setup?
Loving my GS Sub 2.0
Loving my GS Sub 2.0
Under the hood, 60mm #500 loosely rolled solid wick @2.9mm with wick hole drilled out to 3.2mm, with "from bottom up" countersink at 3.5mm.
DID brass nuts with stainless steel washers, 5wrap 28g Kanthal A1 coil at 1 Ohm, second smaller airhole in topcap drilled below original & SV adjustable breather screw with 28g Kanthal spring, CHoo CHoo
![]()
Looks cool, but not sure I understand what is going on. Is there a thread for what you have done here?
This is my stuff.
This is my stuff.