Pictures of your setup

Status
Not open for further replies.

lightbud404

Serial Vapist
ECF Veteran
Verified Member
Jan 23, 2013
379
358
Atlanta, GA
Provari w/ a SS mesh ViVi Neptune = a match made in heaven :D
 

Attachments

  • IMAG0432.jpg
    IMAG0432.jpg
    21.5 KB · Views: 87
Last edited:

studiovap

Unresolved Status
ECF Veteran
Aug 12, 2012
752
1,829
Queensland Australia
Under the hood, 60mm #500 loosely rolled solid wick @2.9mm with wick hole drilled out to 3.2mm, with "from bottom up" countersink at 3.5mm.
DID brass nuts with stainless steel washers, 5wrap 28g Kanthal A1 coil at 1 Ohm, second smaller airhole in topcap drilled below original & SV adjustable breather screw with 28g Kanthal spring, CHoo CHoo :)

8410191764_0b5fc8cce9_c.jpg
 

lightbud404

Serial Vapist
ECF Veteran
Verified Member
Jan 23, 2013
379
358
Atlanta, GA
Under the hood, 60mm #500 loosely rolled solid wick @2.9mm with wick hole drilled out to 3.2mm, with "from bottom up" countersink at 3.5mm.
DID brass nuts with stainless steel washers, 5wrap 28g Kanthal A1 coil at 1 Ohm, second smaller airhole in topcap drilled below original & SV adjustable breather screw with 28g Kanthal spring, CHoo CHoo :)

8410191764_0b5fc8cce9_c.jpg

that looks SICK! :vapor: you just motivated me to go fiddle with my Griffin DID which was sitting around due to a damaged center post insulator. will put her up once I get her hot and heavy.
 
Last edited:

Buzzsaw46

Super Member
ECF Veteran
Verified Member
Oct 6, 2012
658
466
SE MN United States
Thanks.

The DuD is near the top of my favorites list right now, and the VVN is near the bottom. I did just pull the woven circular piece out of it and it does seem to taste a bit better now than it did before. Now I just need to use it a bit and see how it goes, my opinion could change now that it doesn't taste burnt.
 
Status
Not open for further replies.

Users who are viewing this thread