Pictures of your setup

Status
Not open for further replies.

9ball_AJ

On the Snap...
ECF Veteran
Verified Member
I still maintain, that I keep my four rba's in my wife's LV purses, laid flat on the bottom, without worry. :) Not saying all rba's can accomplish this, but mine do.

I concur and attest that a leak free Genny is possible. :)

What rba's are you running that don't leak?

Sent from my phone with an identity crisis.

All 3 of my DID's are setup to be leak free, as well as my Ikarus and my GkmF20. The key is a way to plug the fill hole, and a large enough wick hole to setup a solid core mesh wick with just enough room to allow air in through the wick hole. Common sense would dictate that this would still allow liquid to lead out the wick hole, but in my experience it does not...

And since this is a Pic's of your Setup thread :D Here is a picture. This wicks wonderfully with AVE Hype (90% VG), and does not leak when left on it's side...

IMG_20130705_141112_119_zpsd1c29d29.jpg
 

MoDmAnDaN

Ultra Member
ECF Veteran
Verified Member
May 31, 2013
1,157
1,103
61
Spanaway, Wa.
Finally got my Noble 1.truly amazing for such a small hybrid. I think I found my daily.



Tap'd via G-Note2...

I guess you're liking it then? They are right about it scratching very easy. Already have scratches in mine after a week. And check your battery top every few hours. Even though they say that issue is fixed in this version, I get juice through the center post, condensation I think, vaper Craze is sending me a rebuild kit, so we'll see.

Sent from my phone with an identity crisis.
 
Last edited:

KwhyLE

Super Member
ECF Veteran
Verified Member
Jun 3, 2013
588
1,629
CA
LOL, and a big DOH. I looked at the photo and thought it was an atomizer. I didnt realise that it was the whole device.

It does look great. I like the K100, I would love to get one and refinish it to a nice semi-polished.

haha I was like, I mentioned "IGO-S" in the post.

I thought I would want to sand this one down, but It looks so gosh darn good. I am willing to sand down the chrome parts. I think its chromed brass, so there will be a nice contrast of two shades of brown
 
Status
Not open for further replies.

Users who are viewing this thread