Well finally got around to installing my J-tank on my Boge carto alongside my eGo-T 18650 mod and a shorty cone I got from LF. I wanted to wait until I had a juice that I knew was worth vaping 3ml of (much longer process than I had originally hoped).
The stuff is 100% VG and very thick, so I was (and still am) concerned about it not sucking into the carto properly. I hammered two decently sized holes with a screw, and as far as I can tell it appears to be sucking in the liquid (hard to notice the small level drop since I have only been vaping on it for a little while now). No gurgling or anything strange yet. I will know for sure later today if the level has truly dropped or not or if I am just burning up the filler material in my carto.
Was a lot easier to hammer the holes than I thought it would be, from what I read from other peoples experience, was they seemed to 'dent' the carto rather than making a hole when doing the nail method. I really didn't want to make a mess by using a dremel (or having to buy a dremel) for the slotted method, so I really was hoping this would work for me. I had no problems whatsoever getting a clean hole the first time around, and I really didn't even have to hit it that hard either.
I just used a c-clamp to hold it stationary while I held the screw in place, then proceeded with a few hits with a hammer. Worked like a charm!
So, nothing really special for most of you, but it is for me!
If this does in fact work, my next step will to see if this thing leaks or not. So far so good right now, but time will tell if it leaks in my carrying case or not (an old Snus tin) as I go about my daily life.
It vapes pretty fair. Also made this pass through.
