Pictures of your setup

Status
Not open for further replies.

b0redagain

Resting in Peace
ECF Veteran
Jan 24, 2011
2,562
3,053
Denver, CO
Diver in a 22mm IBTanked tank on the Nemesis.
BTU5JPl.jpg
 

emonty

Flavor Junky
ECF Veteran
Verified Member
Oct 15, 2009
7,612
8,850
the Netherlands
Awesome Emonty! Tell us more!

The DNA 20D is a power regulated digital switch-mode DC-DC converter for personal vaporizers. It features controlled power from 7 to 20 watts, runs from a single lithium cell and includes protective features such as over current, over and under voltage protection and a thermal shutdown. It features a small OLED display, analog or digital user controls, on board buttons and synchronous rectification for maximum battery life and minimal heat generation.

Case is made from die cast aluminum, comes in a variety of colors.
Fire switch is nickel for long lasting durability.
Adjustments are done via 2 dome 300g tact switches.
Internal batteries (2), 15c 1200mah each for a total of 2400mah and enough power to vape sub ohms until they are dead.
Built in USB charger
Dimensions of the mod are 3.64 x 1.52 x 1.06

And it hits hard!!
 

theECB

Super Member
ECF Veteran
Verified Member
Jul 15, 2009
895
590
Everett, WA
upinvapor.blogspot.com
The DNA 20D is a power regulated digital switch-mode DC-DC converter for personal vaporizers. It features controlled power from 7 to 20 watts, runs from a single lithium cell and includes protective features such as over current, over and under voltage protection and a thermal shutdown. It features a small OLED display, analog or digital user controls, on board buttons and synchronous rectification for maximum battery life and minimal heat generation.

Case is made from die cast aluminum, comes in a variety of colors.
Fire switch is nickel for long lasting durability.
Adjustments are done via 2 dome 300g tact switches.
Internal batteries (2), 15c 1200mah each for a total of 2400mah and enough power to vape sub ohms until they are dead.
Built in USB charger
Dimensions of the mod are 3.64 x 1.52 x 1.06

And it hits hard!!

Did you make this yourself? I've been wanting to create a DNA20 mod. Where can I find the enclosure? Also, the cells that are used?
 
Status
Not open for further replies.

Users who are viewing this thread