Pictures of your setup

Status
Not open for further replies.

tyancey00

Senior Member
ECF Veteran
Verified Member
Jan 31, 2013
299
174
st. Louis, Mo
new itazte small.jpg
this is my new VV/VW itazte 3.0 with a pro tank on it. this is a nice set up for me... great vapor and not toooooo big.
 

Lonely Raven

Senior Member
ECF Veteran
Verified Member
Jun 23, 2013
96
163
Bolingbrook, IL
You did very well indeed! My first was a couple of Ego 850's and two ce4 tanks. It's amazing how you can get into the mod trap, so beware! Lol, if this works for you, keep with it.

BTW, Kanger heads can be rebuilt with SS mesh for the wick. I've done a few of them, let's you crank up the voltage and actually get a warm vaperz.

Sent from my phone with an identity crisis.

I'll have to look up how to rebuild them. I'm not sure I care about hot vapor, but I'd like more vapor for some of the weaker flavored juice I have.
 

dmanindfw

Senior Member
ECF Veteran
Jan 19, 2011
76
53
DFW, TX
But your not using those batteries in the Vamo right? It's designed for unprotected IMR type batteries:

AW High Drain Rechargeable Batteries | Best 18650 Batteries

Yes, I use the AW protected Li-Ion cells in it. Had a couple that I bought a few years back for a little (but mighty) flashlight. I know your NOT supposed to use Li-Ion cells in it but I've seen a few posts somewhere that the drain on the big 18650s isn't an issue. Batteries run very cool and don't heat up so they aren't being stressed. Cells are protected from over discharge, overheating, etc., plus the Vamo has it's own protection circuit as well.

I do NOT however run Li-Ion 18350s in it, just the big boys. For the short batts, I use an Efest IMR although it rarely gets used as the Vamo in the long form fits my hand better.
 
Status
Not open for further replies.

Users who are viewing this thread