please help identify this model

[Stosh]

Any tank, carto, clearomizer, that is 510 threaded should fit and work on your mod. If you get a 510 to ego adapter, you could use most anything.

Look for about 2.0 ohm to 2.5 ohm for a easy enjoyable vape...

 

[yosi]

Any tank, carto, clearomizer, that is 510 threaded should fit and work on your mod. If you get a 510 to ego adapter, you could use most anything.

Look for about 2.0 ohm to 2.5 ohm for a easy enjoyable vape...

thank you, Stosh. this and other info i've gathered so far will help set me up to a longer haul this time, i hope (after the starter kits that lasted in a couple of months).

just a quick question: i'm looking forward in getting rebuildable cartos for the 18650, 2000 mAh battery. my target resistance for the diy nichrome wick would be in the 2 to 2.5 ohm range. am i correct?

or can i go for a range of say 1.0 to 2.5 ohms without affecting the 13c battery?

 

[Stosh]

A 2.0 - 2.5 ohm range would be least likely to burn your juice. The lower the resistance the hotter the coil will get, and the faster it will heat up. That's a good thing until you get to the point where the juice is burning before you can draw a vape.

More power is a good thing, but when you get to the point where you drop the clutch in first gear and get nothing but tire smoke from spinning your wheels, you won't be going anywhere fast....

 

[yosi]

good advice, Stosh. will keep that in mind.

but the "clutch in first gear" analogy is even better. lol