Plugged Atty's

[musickangel]

So I have my favorite juice the wintergreen/dbl flavor from vixen vapors and since I have been using it I can not get an atomizer to last me even a week before the seal or plug in the bottom starts blocking the air holes and Its completely unusable. I have had this happen on my joye 510 Lr attys and also my 206 lr attys.

I'm currently vaping on the ego-c 1000mah batteries or an eco 1300mah battery. I've tried the juice in the standard ego-c tanks but it doent produce any flavor and thats why I love this juice, the flavor is amazing.

excuse the iphone pic, but you can see the white seal in the air hole

any suggestions are appreciated!

-Angel

 

[wseyller]

I have a smoketec 1.5 ohm single coil carto in my tank. This carto came with the tank and it is not even a day old. I used half of the liquid in the tank just fine. I noticed a tight draw a while ago and that white object is covering half of the vent hole. I am also curious how that happens. First time I've seen any thing like this.

 

[musickangel]

I've had this happen to about 8 atomizers i've gone through two in the past day What type of juice are you using? mine started when I started vaping this wintergreen juice.

 

[wseyller]

It is a juice I made: Vanilla bean ice cream.

 

[musickangel]

So vikki from cognot walked me through taking apart my atomizer by pulling the center post on the bottom out and then I pulled the small plug/seal out and cut off a small piece one one side where it was plugging my atomizer air holes. then I put the seal back in and it works great!! Just don't cut off all the seal or else its like vaping through a straw.

 

[wseyller]

So vikki from cognot walked me through taking apart my atomizer by pulling the center post on the bottom out and then I pulled the small plug/seal out and cut off a small piece one one side where it was plugging my atomizer air holes. then I put the seal back in and it works great!! Just don't cut off all the seal or else its like vaping through a straw.

Nice tip!!!

 

[six]

A 1.0mm drill bit will fit in most of the 510 atty air holes and you can bore through the blockage with twenty or thirty revolutions (no drill needed - just spin it with your fingers). When it happens to a 306, they sometimes have slightly larger air holes and a 1.15mm bit might be the right one.

 

[Unforeseen]

Moved from General E-Smoking Discussion to Atomizer, Cartomizer, and Tank Discussion

 

[musickangel]

A 1.0mm drill bit will fit in most of the 510 atty air holes and you can bore through the blockage with twenty or thirty revolutions (no drill needed - just spin it with your fingers). When it happens to a 306, they sometimes have slightly larger air holes and a 1.15mm bit might be the right one.

Awesome i'll have to try that!