Post your Volts and Ohms please

[Bronze]

Please tell me the volts and ohms you have in your clearomizer setup. Please, clearomizers only! I want to gather some data on this just to get a feel of what the average range is. If you're not sure of the voltage of your battery then just state what battery you are using. I'll figure it out. I'll post the results when I feel I have enough respondents. Perhaps 10 - 15 at least. Thanks

 

[skelley]

I use a VVPV and adjust voltage to taste.
I'm normally in the 6-7 watt range.
I have devices that range from 1.8-3.0 ohms and juices are either 70/30 or 50/50, PG/VG respectively.

Some juices seem to burn off the flavor at higher watts.
I would say that my juice dictates my wattage as I will take the volts up as high as I can go w/o loosing flavor.

It's like trying to fine tune a engine. I have to adjust fuel; air & fire to obtain optimal performance.
Voltage can be controlled on my VVPV; Air can be controlled by draw; fuel delivery being controlled by the device with the goal of obtaining best flavor/vapor combo I can get.
Once I control those aspects, it still boils down to the octane

 

[kwalka]

Here is a universal Safe Voltage Ohms Range chart. This applies to any battery and resistance combination. I'm not sure if this is what your looking for but this is good for all to have...

 

[Yves]

KGO with 2.4 Vision Ego clearomizer. Twist I use 1.8, and 2.4. clearomizer. Hope this is what you were looking for..