power adapter

Status
Not open for further replies.

ruuku

Senior Member
ECF Veteran
Verified Member
Mar 21, 2009
278
17
Honolulu, Hawaii
There's a whole stickied thread concerning this topic...
In brief: (I used the 901, N connector) The post connected to the center pin is your positive, and the post connected to the outer ring is your negative contact. However there are three posts, find the post that is not the positive nor the negative, and you can snip this off. I used this tab (cut flush against the panel, and bent it in half it to act as a bridge between the ring of the negative side of the panel to the actual connector (a bit of solder would be preferable). If you use the washer and lock nut then the atomizer fully screwed in will not be able to contact the center post, as it is recessed within the jack. You can either add a bit of solder, a wire or even a small ball of tinfoil to extend the center post, just as long as it bridges about a 1-2mm gap it will work.

http://www.e-cigarette-forum.com/forum/battery-mods/14364-how-dc-jack-901-fitting.html
 

allure

Full Member
ECF Veteran
Apr 22, 2009
65
1
Lake Forest,CA
Status
Not open for further replies.

Users who are viewing this thread