Prepping a new atomizer

[Carla Sebrina Spahos]

Hello everyone,

I decided to take the plunge and try using an atomizer. I usually use a DCT carto, which I'm very happy with, but wanted to try out atomizers as they look like fun, and a great way to try out new flavors or switch out flavors more often than a carto.

I didn't want to go right into rebuildables, so I purchased two inexpensive
[h=3]510 smok Tech 2.0ohm Atomizers[/h]
What do I need to do with these to prep them for first use? Should I do a dry burn with them? I know some attys you can do that with, but wasn't sure with these. I would hate to ruin them before getting a chance to use them. Any suggestions? Thanks!

 

[GordyK]

Is this a rebuildable atomizer you speak of? If so which one?? SmokTech makes quite a few so I'm kind of confused by your question.

 

[Unseen]

Take the thread end and blow into the little hole. Make sure you get all that primer out of there or it'll make you gag. Then drip about 4 drops and dry pull it (don't push the button). If you hear a gurgle a real slight one you're good if not add another drop. Then start vaping adding 3 drops when you feel flavor drop off or hear it hissing at you. Enjoy.

 

[Thrasher]

usually you just blow through them to remove and left over priming liquid.
then either drip and go or some people even rinse them first. i just fired em up with some juice after blowing through them and ignored the first few puffs til they got going.