Protank 2 base won't let airflow

[DrillRX]

My PT2 base stopped flowing for some reason. It was like one second it was working great and the next time I put it on....bam...no airflow. So I use my mini PT2 base for my regular PT2 and it works fine. I read somewhere that taking the little white rubber cap that sits on top of the wicks can be removed to make a better vape, but it seems as if it might flood if I do that. Any thoughts? Thanks.

A cheap 510 airflow controller should do the trick ($5). It works for me on those mods that don't have a lot of air channels

 

[SPeteW]

Tried to quote a post but screwed up. Anyways a reply about Protank III head parts for Protank II.

The only parts you use from the protank III head are the inner insulator and the positive pin that goes in the insulator. The Protank III insulator is easier to install and holds up better to dry burning. The Protank III positive pin is cut out on the base which makes it easier to cut the wire flush and install. Those 2 parts work perfect and there is no issue.
I wish I could buy these insulators but can't find them anywhere. Kidney puncher has similar insulators that I have heard work in the Protank II but they don't look the same so I have not bought any.