Provari ce2 problems?

[boise2011bjt]

I tryed two diffrent ce2 510 connection clearomisers on my Provari and they wouldnt come close to screwing on to make battery contact. They fit on evreything else 510 connection i had. I emailed provape they said theres alot of clearomisers that are not made well from china. Huh? Has anyone else had this problem? If its 510 it should fit 510 it fits all my other 510 connections. What kind of attys is evreyone useing to drip with?

 

[TheJack]

I know how to fix this problem but its hard to explain. on the outside of the lower part of the ce2 you will have your threads. if you into the bottom of the connection you will see it has 2 parts. "inside connection" and the "outside connection threads". if you get a pin. a little needle and gently pry the inside outwards it will give you contact. its the part with the hole in the middle. these 2 parts are separated by a little piece of rubber so they dont make contact with each other. just slowly work the inner part down and you should be golden. just take your time. you dont need it down to far just enough to hit the bottom of the 510 connection.

 

[boise2011bjt]

Thanks for the info. Do all Provaris have this problem?

 

[TheJack]

no, i noticed it on some ce2`s and adimizers from Volcano. i have a few different setups so i had to figureout the problem.

 

[leftfeild]

TheJack nailed it. I've had some issues on one of my box mods with different cartomisers. After I used them on the ego it pushes the threads up a little if I put it on too tight so it wont connect to the base of the box mod anymore. Just have to pull them down gently so it'll make contact again. It can happen to anything that uses the cup style 510 connectors. If you have an ego it has a bigger pin in the middle, and that there was the problem for me.

You could get a cheap 510 to 510 connector that's meant for skirted atomisers like the ego T ones that might not be quite as deep. Not sure where you could get one though.

EMDCC's, DCC's and CE2s have done this to me now and then. Good luck man!

 

[entwined2969]

I bought an inexpensive 510 extention, and have been a happy camper thus far. Shorty 510 Extension and Connector

 

[madjack]

...this sounds more like a CE2 problem than a ProVari problem...there is a ProVari section on this forum and you should get better and more specific advice there, rather than here on the newbies forum...imjusayin..........
madjack

 

[boise2011bjt]

if it would let me post there i would

 

[madjack]

...have you tried lately...you should now have enough posts to post over there..............

 

[Tersur]

Ive always avoided Ce2 gear after my first experiance with it.