Hello all, I recently purchased a new Provari P3 and really like it thus far just a couple of weird quirks.
It seems to dislike atty's that are above 2 ohm when the boost feature is on. I have tried several different tanks on it ranging from vivi-novas, iclear 30s, pro tanks 1 and 2, vapeonly BCC, the results are the same. The device will flash an warning above the ohm rating and the error msg says the wattage is too high. I can reduce the wattage all the way down and the error remains until the boost is turned off. Now the device performs beautifully and the error msg is little more then annoying but just wonder why it shows that error? Also the ohm reader seems to not pick up the correct reading right away or is a little off compared to other devices I own. For example the ohms read just right on my Innokin, Cloupor, and dna pieces so IDK..? The Provari may be just a little slow to pick up on the correct ohms rating, just wondering what everyone's thoughts were?
Thanx in adavance,
Peace!
It seems to dislike atty's that are above 2 ohm when the boost feature is on. I have tried several different tanks on it ranging from vivi-novas, iclear 30s, pro tanks 1 and 2, vapeonly BCC, the results are the same. The device will flash an warning above the ohm rating and the error msg says the wattage is too high. I can reduce the wattage all the way down and the error remains until the boost is turned off. Now the device performs beautifully and the error msg is little more then annoying but just wonder why it shows that error? Also the ohm reader seems to not pick up the correct reading right away or is a little off compared to other devices I own. For example the ohms read just right on my Innokin, Cloupor, and dna pieces so IDK..? The Provari may be just a little slow to pick up on the correct ohms rating, just wondering what everyone's thoughts were?
Thanx in adavance,
Peace!
