Question for GG slim owners

[kaji]

I just got my GGS after being out of town for work. I threw in a battery and screwed on a 901 atty and noticed that the atomizer was not screwing all the way down. I tried another 901 and had the same results. Next I tried it with a 510 adapter and 510 atty and had the same issue. In all cases my GGS would still fire even with a gap of about 1mm.

So it appears the the center pin on my GGS is about 1mm too long, the only way I am able to eliminate the gap, is by unscewing the center pin inside the GGs by about 1mm, to lower the pin down far enough so the atomizer and or adapter/atomizer can sit flush.

Is this normal?

 

[sadtranz]

Try unscrewing button does it screw all the way now? if not it is the centre post loose ie is free to move up and down?

 

[imeothanasis]

Kaji, you are more than right. Atomizers dont screw totally because I wanted 0,5-1mm space in case of deeper atomizers or atomizers with bigger center pole. But yes, unscrewing the center pole its the trick. Maybe you understand GG more than good buddy!!

 

[kaji]

Thanks Imeo, I figured it was designed that way to allow for different tolerances in attys. I just wanted to make sure, thank you for the clarification.

 

[imeothanasis]

Thanks Imeo, I figured it was designed that way to allow for different tolerances in attys. I just wanted to make sure, thank you for the clarification.

If all customers were like you and some others here then I would be more cool buddy