Quick mesh ordering question.

[chadsmo]

I was lead to The Mesh Company in the UK to order some supplies. They seem to have different qualities of mesh you can order and before I pull the trigger I want to make sure I have the correct one.

WSS400F-A3 Super Fine #400 E-Cig Stainless Steel Mesh - 0.03mm (30 Micron) - A3 Sheet - Bargain Alternative


Is the micron spacing on that good ? It says that its great for e cig wicking , but they have more expensive higher micron stuff too so I was curious.

Thanks.

 

[kingdal]

I think the consensus is the #400 is good but the #500 is better. I've tried both and cant really tell much of a difference.

 

[chadsmo]

I ended up ordering an 11x16 inch sheet of 400 30 micron. In figure that will give me a lot of mesh to play with. Also grabbed 100ft of 32g kanthal off eBay too. Now to order my AGA T2 and I'm off to the races.

 

[Xylocaine]

Best of luck, make sure to check out the Aga T+ thread (it ca be a lot of reading at this point and there is a lot of band-aid methods but you can glean the proper techniques easily).

 

[Devilok]

I use #400 only and have tried the #500 and like Kingdal I could't tell any difference, so I've stuck with #400.

 

[chadsmo]

Best of luck, make sure to check out the Aga T+ thread (it ca be a lot of reading at this point and there is a lot of band-aid methods but you can glean the proper techniques easily).

Thanks , I've sort of read most of that thread already. And I've watched a ton of YouTube videos on genesis RBAs so I think I'm in a pretty good spot to hit the ground running. I'm not expecting amazing things right away but I'm in pretty good shape I think.