RDA Round-Table Discussion and Lookout

[Henry Etta]

This is one I'm waiting for... the Mulciber. $60-$70 price range, and also will be readily available.

"Chamber diameter: 18.5mm OD/15mm ID
Two AFC rings and positive screws are stock. A single 7mmx1.5mm slot and a double. One standard positive pin and one squonk compatible positive pin.
Velocity posts with flathead screws for single, dual, and vertical coil builds. The wire holes are 1.7mm in diameter.
The bottom slot is the exposed one for single coil builds - this allows for additional throat hit, but the dual slot can be adjusted from a lung hit to MTL effectively if you prefer a smoother vape."

But production is stalled, so no word yet on when they'll be available.

All of my recent purchases have been very disappointing (O-Atty, GP Dripper, HF Havoc) because none of them work well with the airflow closed down. So no more chasing the best new thing without reviews first...

 

[pls0138]

Just tried to pre order the hadaly from bevapehappy.com and just experienced my first encounter with the new FDA regulation bull..... Had to take a picture of myself with my ID, a picture of my ID and give them my last four digits of my social. Waiting now for the "conformation" before I can officially place my order. This is the first site I've had to do this, and I've ordered e liquid from several sites over the past month, I would think these sites would have been more likely to do the age verification early on since the product they sell actually contains nicotine. Obviously I've been aware the regulation crap for a while now, this is just the first time I've dealt with it straight on.
Anyways, assuming that all goes through, I'm very stoked about this rda! This is the most money I've spent on an atomizer, I've always gone with the cheaper ($30ish) authentics up to this point (Mutation X, Freakshow, etc). But like I said before, this atty looks to be the perfect design to me, so I'm willing to take the chance and pay double what I normally pay. One thing I did notice was there doesn't seem to be a 510 drip tip adaptor included or offered for this rda. I prefer a 510 drip tip so I hope that this is an accessory that will be offered in the near future

 

[muzichead]

Had to take a picture of myself with my ID, a picture of my ID and give them my last four digits of my social.

I'll quit vaping before I go through that !!!

 

[r055co]

Here's what I am currently wondering about

Goon LP
I like the goon but its big and really caters to volume over flavor that being said it does have alright flavor for what it is. Also by the time i choke the air down to what feels right to me it just dosnt vape right and the vapes is choked out. However a much shorter goon with a higher degree of control over airflow actually sounds good for either dual coils or using some more advanced coil types that I am unable to use in my Narda or Hobo 3.1.
.

I like the Goon but I do have better RDA's I enjoy more.

.

The Doode RDA
I have to admit I really just want to try out the chuck/deck system however I'm not sure if I want to try it badly enough to drop $60 on it. Regardless not really my cup o tea


O-Atty
Unfortunately I might have to pass on this guy and pick up the clone. It looks amazing but dash vapes in Canada is the last place still offering pre orders and it would be $170 shipped ugggghhhh.

$170, does it come with Hookers and Blow?
Way too much, insane.

.

Prophet RDA
Again not my ideal RDA (it seems 90% of the market is focused on large footprint large vapor atomizers) however it looks like you can toss a nice sized single fused clapton in it close it off a bit and get some pretty good flavor and vapor from it..

I like mine, love postless decks.

.

Does anyone here have anything else they are hyped or excited about ???? Hook it up peepz I don't cruise instagram nor am I members of any FB groups so I hardly have the scoop on anything new.

For a flavor Monster I love the United Chaos, excellent machining and the flavor is excellent, best I've found.

.

I build my own Clapton's and other advanced wire varieties and its one of my favorite things about this hobby and part of my problem is that my taste in vaping has gravitated towards smaller chambers and tighter controlled airflow which just does not jive well with framed staggered staple wire lol however I recently started experimenting with micro Clapton's and have some really nice 2x28gx40g and also 2x30gx38g Clapton's that still put out more flavor then round wire yet are cool enough to be vaped in smaller RDAs.

I don't like any wrapping wire larger than 34g. I build a lot of 29x2/36 SS fused Clapton, that's my go too.

Sent from my Nexus 6 using Tapatalk

 

[Texasbox]

I just got a Tesla clapton rda. The flavor is intense and clouds are massive.

Sent from my LGLS991 using Tapatalk

 

[phanner]

This is one I'm waiting for... the Mulciber. $60-$70 price range, and also will be readily available.

"Chamber diameter: 18.5mm OD/15mm ID
Two AFC rings and positive screws are stock. A single 7mmx1.5mm slot and a double. One standard positive pin and one squonk compatible positive pin.
Velocity posts with flathead screws for single, dual, and vertical coil builds. The wire holes are 1.7mm in diameter.
The bottom slot is the exposed one for single coil builds - this allows for additional throat hit, but the dual slot can be adjusted from a lung hit to MTL effectively if you prefer a smoother vape."

But production is stalled, so no word yet on when they'll be available.

All of my recent purchases have been very disappointing (O-Atty, GP Dripper, HF Havoc) because none of them work well with the airflow closed down. So no more chasing the best new thing without reviews first...

REALLY interested in this one. Thanks!

 

[Henry Etta]

REALLY interested in this one. Thanks!

The initial reviews on this are really good- I can't see how this won't be a great atty, as long as the machining is decent.

 

[zoiDman]

Just an FYI.

It looks like Focalecig will be selling an O-Atty Clone soon.

focalecig.com - Oatty Style Atomizer with Bottom Feeding Pin by ShenRay - Silver

 

[Sed8op8]

Just an FYI.

It looks like Focalecig will be selling an O-Atty Clone soon.

focalecig.com - Oatty Style Atomizer with Bottom Feeding Pin by ShenRay - Silver

Thanks for the heads up I have this pre ordered it looks like expected shipping is 10/22 but you. Never know 3f vape briefly had an O Atty Styled listing up but when i checked back it was taken down so i dknt know if Odis is trying to keep the word from spreading that There's already a clone....shrug.... I'll be sure to check back once I get it to give everyone my thoughts 8) thanks Zoid

 

[havok333]

Just an FYI.

It looks like Focalecig will be selling an O-Atty Clone soon.

focalecig.com - Oatty Style Atomizer with Bottom Feeding Pin by ShenRay - Silver

Was feeling froggy so jumped on this too! Thanks for the heads-up! [emoji482]

Sent from my XT1049 using Tapatalk

 

[Hank F. Spankman]

Was feeling froggy so jumped on this too! Thanks for the heads-up! [emoji482]

Sent from my XT1049 using Tapatalk

Ditto! lol

 

[Sed8op8]

Aeronaut 24 RDA
Just put my order in for the aeronaut 24mm and I have to say I am very excited. I loved the 22 but it had its foibles but this really alleviates them all for me add to the fact there will be a BF pin and I think I'm in heaven. Between this and the hadaly im set for that #SingleCoilLife

 

[Henry Etta]

For anyone not in the loop: Hadaly goes up tomorrow 10am EST-- Psyclone Mods
There will be 4000, plus ultem & delrin top caps.

And Mulciber will be up in a couple of weeks-- Tiberian Vapor Co.
There will be plenty of these too, and the RRP is $65!
These are 22mm with a 16mm inner chamber.

 

[Rex Everything]

Any Tugboat v2 fans out there....Flawless is blowing out TB v2, v3, dinghy's, and the anarcist rdas for $20-25

 

[Train2]

I'm gonn have to get a Hadaly.
Like the design, and the caps...

 

[Sed8op8]

I can't wait for the inventory to become available on the site so I can grab an ultem cap for mine 8)

 

[Hank F. Spankman]

Any Tugboat v2 fans out there....Flawless is blowing out TB v2, v3, dinghy's, and the anarcist rdas for $20-25

lol I've been pimping the crap out of this sale

 

[Hank F. Spankman]

If anyone's looking for chuffs/510s/Goon, tips or caps crispycaps is running a 20% off code. I use the heck out of the Flav chuff on the Stumpy

 

[jhhollier]

Hadaly and Ultem cap ordered. It's gonna be hell waiting for this vape mail.

 

[Mr.Mann]

Hadaly and Ultem cap ordered. It's gonna be hell waiting for this vape mail.

The fact that this is not a "FB thing" -- no x1 -- makes it that much sweeter. The icing is the price.