Rebuilding coils

[Kiva]

So I am trying a lower resistance coil for the first time and with 3 wraps of 32awg it's coming out to about 1 ohm on my eVic. After messing with the coil it seems to be all lighting up at once. What Im wondering is if after I put liquid in my tank, if the top leg of the coil that goes to the positive post is supposed to get orange at all?


Sent from my iPhone

 

[Rule62]

No, you should not see any glowing when the tank is full.

 

[Kiva]

That's what I thought.
Any ideas on what would cause it?


Sent from my iPhone

 

[vapdivrr]

if you want to try a 1-ohm coil I would recommend using a thicker gauge wire. for the most part 32g is not for low resistance. 32g is a high resistance wire and produces more heat then a thicker wire, this could make for a harsher vape then with a thicker wire. at least try 30g and then if you like it even a 28g. I didn't know the e-vic can do coils that low? I personally believe that with a vv device you would be better doing a coil in the 1.2 to 1.4 range. if you really want to go low you need a mechanical mod

 

[Kiva]

I was planning on ordering some 30awg when I buy more mesh tomorrow.


Sent from my iPhone

 

[varivapr]

the purpose of a low ohm coil is to draw high amperage using a mechanical mod. you will be benefit from using a low ohm coil on an evic. It maxes out at around 11w any way you slice it. 2ohm coil or 1.2 ohm coil it will run the same wattage.