reo button

[nepatitan]

What else can I put under the button top to raise it, I lost the little plastic pipe that goes under the button top.

Thanks

 

[Della Cirque]

The big delrin button cover?
I use a tiny o-ring from a trippy tip.

 

[nepatitan]

Yes, cool thanks

 

[ltrainer]

Some Reonauts have been known to use belly button lint. I opted to a small rolled up piece of paper.

 

[FACE MEAT]

I used the left over shrapnel of a V-mod that I put through a wood chipper.

 

[nepatitan]

ohh.... lol

 

[nerak]

http://www.e-cigarette-forum.com/forum/reos-mods/392040-what-stuck-your-button-top.html

 

[nepatitan]

lol I hope there is a good story behind that

 

[nerak]

lol I hope there is a good story behind that

It is a link. Click it for the thread. LOL!

 

[nepatitan]

lol I meant @facemeats story.

It is a link. Click it for the thread. LOL!

 

[irehc77]

Well I have two Reo Grands. One has the button cover and the other does not. I purchased one from Rob but it must be just a little to larger because is slips down after I put it on (Using the tube spacer) and then of course you can't push the button down. I do like the button on the one I am using but the other one must just be slightly to large. Just took it off and have it in a drawer so ideas to prevent this would be helpful!

 

[ltrainer]

Tear off a small piece of paper and put it inside the button but on the side to act as a shim. If it still slips put a larger one or double the paper over and place that on the side inside the button. Eventually you'll find a spot where it will snug down nice and tight and not move.

 

[Filthy-Beast]

Well I have two Reo Grands. One has the button cover and the other does not. I purchased one from Rob but it must be just a little to larger because is slips down after I put it on (Using the tube spacer) and then of course you can't push the button down. I do like the button on the one I am using but the other one must just be slightly to large. Just took it off and have it in a drawer so ideas to prevent this would be helpful!

I used a piece of a plastic baggy over the original button, pushed the top on and then pulled off the excess baggy, holds very tight.