Right tools for the job

[ancientgeek]

I have too much time on my hands. Here is the coiling station I built. This along with scissors and tweezers is about all i need.

To use: clamp one end of kanthal wire under nut and then just crank out the number of wraps desired. Undo the clamp nut and slide coil off the mandrel and it is ready for heat treating and installation in the atomizer of your choice.

 

[ta2dave76]

This is what I use.

 

[vapero]

this is what I use just put the tail on one of the grooves, hold with your thumb and coil

 

[ta2dave76]

there is this RBA Workbench with Rechargeable ohm meter

Lol thought we were supposed to save money by vaping?!?!?!?!?

My little kit, $0. And the wire was free!