RM2 Cap is STUCK.
- Thread starter w0nt0ns00p
- Start date
- th_trl_thread_readers 0
- Status
Happens to mine all the time! I just use needle pliers to grip the bottom brass portion and stick a tiny screw driver through the air hole and turn , works every time. Good luck !
My first Reo with Reomizer is due in tomorrow. Both low profile. Hoping that I don't have the same issue. I have RA and have very little hand strength-may be "calling" out for help from y'all when it gets here. LOL
Don't let it worry you mommabird, it's not a frequent issue. Just make sure you don't tighten the cap on, just light finger pressure is more than enough
I've got bad hand-strength as well; I feel your pain lol. Thankfully Rob is incredibly understanding and has provided nothing but fantastic customer service so far!! Great experience so far even without being able to get the reomizer open and try it out
A word of caution here, it's best to screw on the atomizer base (only) to the REO first, then just barely snug the cap on. It's been suggested frequently that one really should build new coils wicks while the RM2 is attached to the REO, constant removal/reattachment (dodged that one, huh? 
) will wear the threads over time.
I use a hold from J-Wraps that allows me to do that easily (build on the mod) and using that, it's a piece of cake to test resistance with an ohm meter.
) will wear the threads over time.I use a hold from J-Wraps that allows me to do that easily (build on the mod) and using that, it's a piece of cake to test resistance with an ohm meter.
Thanks y'all I am going to go back and watch the vids on the website again while I stalk the mailman tomorrow afternoon. LOL I normally have few issues with the gear that I have now so hopefully that will carry over
I am going to go back and watch the vids on the website again while I stalk the mailman tomorrow afternoon. LOL I normally have few issues with the gear that I have now so hopefully that will carry over 
I made the guys check every rm2 in the boxes today I found the problem and rectified the problem . Its always the new guy
Thanks y'all
You and me too!
"Hey boss, I can do them really quick with this thing!!!"
Guess someone was using the air impact gun to put caps on right? LOL!
Thanks for diagnosing the root of the problem, Rob! Still have yet to get mine open but the customer service and double-checking like that is what's keeping me SUPER hopeful for this Reo bandwagon!!
but the customer service and double-checking like that is what's keeping me SUPER hopeful for this Reo bandwagon!!
No impact wrench lol Just a guy not using his head . I guess he figured I didn't have enough to deal with .
They were all involved as far as I was concerned .TY Rob
Thanks for diagnosing the root of the problem, Rob! Still have yet to get mine open
Couple of rubber bands and some pliers. Just go slow and easy.
- Status
Similar threads
