Russian 91% help

[DaxFX]

Hey guys, ive being using my russian for a couple of weeks now, so far the best thing on earth ive try.

Today i went to a full cleanup build a new microcoil with cotton endup at 2 ohm with 30g kanthal 9wraps. But now my draw is like a vivi nove tight with airflow control wide open, i was getting a good open draw on my other builds,

Do i need to align airhole on center pin, since the intake is crooked i dont know how to align the center pin holes. Any suggestions?

Sent from my iPad using Tapatalk HD

 

[sandt38]

Grab the center post block and ground post block at the same time with your tweezers to prevent the center post from turning. If it is not aligned you will have restricted airflow.

 

[DaxFX]

Grab the center post block and ground post block at the same time with your tweezers to prevent the center post from turning. If it is not aligned you will have restricted airflow.

How do i know if the center post is correctly aligned?


Sent from my iPad using Tapatalk HD

 

[DaxFX]

I found the issue, the coil and cotton was to close to the hole. I pulled up a bit put new cotton into the coil, vuala my big clouds are here again.

I dont thinck that the hole in the center pin rod needs to be align like the KFL I did try to pull air while screwin and unscrew the center rod, and didnt notice any diference, unlike the kayfun lite the intake in the bottom cap is not ailgned to the center rod, there have to be some air space around the hole of the rod inside the bottom ive try putting a drill bit thru the intake and rotate the rod trying to feel the rod and i was not feel anything, i just but back together everithing thight the center pin tight as always pull my coil a litle bit up and holy vape ....


Sent from my iPad using Tapatalk HD