Siam Mods Pyrex tank

[invididual]

Specifically, the caps, I received 2 sets of orings with it when I got it, but one gives it a slidey DCT feel when it's on the carto and the other, I can't get the carto through the bottom. Has anyone found an oring that works for these?



Sent from my Galaxy Nexus using Tapatalk 2

 

[peteyboy]

Have not used these, but that is a good looking set-up you have

 

[anavidfan]

I thought these were just beautiful, but I saw a review on PBusardos review of the phiniac. He has a chart that shows the slip ratings and those were on the lower end, above smoke techs with from experience slip off if you touch them wrong. Might contact the vendor and ask for assistance or just tell them you are not satisfied. If you want a nice inexpesive tank you should check out valley vapes Vtanks, great price and from what I hear pretty hard to get it to slip. I just ordered 2 of them. If you want to pay a lot more for a tank that for most its considered the best, get a phiniac. On that video review, phiniac was the highest not to slip. These are tight. They also dont crack and you can use any type of juice with no worries of cracking.

 

[invididual]

I watched the pbsusardo review on the Siam tanks and saw it was slidey and got it anyway, bad choice, cool tank, too slidey, I put one of the tighter orings in the drip tip end of the Siam tank and it's fine, probably only till it needs refilling, then it'll be a headache again, at least it won't slide around in the meantime

funny enough, I do have one of the VVV Pyrex tanks, with the aluminum caps, it's enormous.

Sent from my Galaxy Nexus using Tapatalk 2

 

[anavidfan]

i was having problems when refilling the tank also, tried the method of filling it from the bottom end of carto, and tried the top holding the carto a bit to the side, still had a mess. I went to a local store( e-cig city) and got some needle and syringes. It works fantastic. I use 2 holes on bottom and one on top. I found that because of this, while I was filling the tank, that the juice was running out thru the holes or from the tiny space I created from pushing carto to side to get enough space to drip the juice in. Now with the needle I dont need as much space and no mess. PS. glad you got your siam tank going. Glad it was a cheap and quick fix with the orings.