Simple 6V mod in 2AA box

Status
Not open for further replies.

Mentat Ix

Full Member
Sep 5, 2010
40
0
SO CAL
I got some protected CR2s to play around with, and here are the results:

2w39b4o.jpg


2evs288.jpg


dwuqn9.jpg


Took a little creative dremel work, but it vapes like a champ and it's pretty small. Only thing it needs is a smaller switch. The flashlight is just a 14500 mod that happened to be on my desk..
 

Mentat Ix

Full Member
Sep 5, 2010
40
0
SO CAL
I've been using one of these on all my plastic stuff: Dremel #192 Ball Tip High Speed Steel Cutter | Dremel Cutters

Works miracles without the melty effect, for the most part. Probably took me about 10 minutes to do the box.

The protected CR2s I got from madvapes are doing pretty good for me so far. Holding up better than the 14500s, trustfire or ultrafire either one :( Maybe my luck is just weird.

Unless you meant how long a set lasts.. in which case, the cr2s are lasting me about one day, where the 14500s I run in my 5 volt mods are doing 2-3 days, before the wrappers come off and they fall apart or stop taking a charge third time I use them. I'm a fairly light vaper, though I am running high nic juices and getting huge volumes of vapor with my boge cartos at higher voltages.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread