RDA Single Macro Coil Only RDA?
- Thread starter sig-cmt
- Start date
- th_trl_thread_readers 0
- Status
3.5 mm Dia coil is very large you sure you have that right?
The new Youde UD Bellus V2, dual coil that is able to be used as single coil.
5 ml capacity, top fill and side air flow. I picked one up from efun.top on sale $18.50 + $4.00 shipping = $22.50
Best of all my tanks.
The new Youde UD Bellus V2, dual coil that is able to be used as single coil.
5 ml capacity, top fill and side air flow. I picked one up from efun.top on sale $18.50 + $4.00 shipping = $22.50
Best of all my tanks.
Yes, sir. 22g Ti coil @ ~3.5mm off a #10-24 machine screw. Fits in The Kennedy 24 and the Velocity with no clearance issues (so long the number of wraps are limited). The Origen Genesis V2 MKII can do ~3.25mm off a #8-32 machine screw if one is careful, but I cannot achieve the number wraps to target a resistance above 0.1 ohms with a spaced 22g Ti coil due to minimal top cap clearance.
Thanks, I'll take a look. Though I would prefer a strict RDA or a Genesis-style atomizer...
Last edited:
Got this few days ago and there is very much room to build as you can see.
I like it.
http://vape-street.com/hannya-rda-by-blitz-enterprises/
I like it.
http://vape-street.com/hannya-rda-by-blitz-enterprises/
That looks interesting. It looks as if the top cap has holes drilled out for anti-spitback. Or is there a removeable mesh screen installed in the top cap? I hope that bottom o-ring can contain leaks from the set screw holes. @Hanha: Any additional thoughts on the Hannya?
Well I only had it couple of days and had only few builds in it. I just like the fact that there are no posts in the way and no need for offset coils.
Anti-spitback is NOT removable. And the bottom o-ring is preventing leaks cause its below the screws.
This video made me buy it.
- Status
