From the CCV site:
Any ideal on the price for the zmax?
Between 118 or 128 smoktech set a minimum pricing, just ordered 50 chrome and 50 SS Really cool set wattage can grab any of dozen different carto's no matter what the ohms are vape pretty much the same. Can definetly feel the button click, it barely sticks out also, no led in buttons
OFFICIAL: CyrstalClearVaping.com Information Thread..-2012-08-22-22-29-36.426.jpg
Zmax User Settings
Features:
Zmax is a new intelligent e cig Mod,except could adjust the voltage,it also could adjust the wattage.It could use one 18650 battery and also could use two 18350 batteries with extra longer buttom cap.It's a constant voltage and constant wattage new VV Mod.
Zmax can be adjusted from 3.0-6.0V volts in 0.1 volt increments.
Built-in three digit display allows you to visually adjust your voltage and wattage.
Zmax could fit one battery 18650 or add holds two specially designed 18350 High Power Batteries,and reverse connect protection.
ZMax is made of brass or stainless.
Zmax is with 510 and EGO thread,blue LED display.
With a maximum output of 15 watts.
ZMax can be adjusted power from 3.0 --15 W in 0.5 watts increments.
ZMax PCB allows 5 Amperage output limit.
ZMax buttom never get stucked even theres a 360°turnning around
The menu is arranged in the following order:
1.Uu --- Voltage up
2.Ud --- Voltage down
3.So --- Standby on/off
4.Uc --- Voltage check of battery
5.Ds --- Display change
Do --- Display cartomizer/atomizer output voltage
Du --- Display battery output voltage
DR---Display cartomizer/atomizer resistance
6.Lo --- Led light on/off
7.Up --- Voltage power
Po --- Constant power operation
Uo --- Constant voltage operation
Same exact size an shape as vmax. Vapes like a dream. Using a efest 18650 2000 imr in it now, but yes your 350's will work fine with 5mm ext. cap, my Efest 2250mAh 18650 be here Monday.
Other Functions
Low Battery Indicator --- When the battery gets low the red lighted pushbutton will slowly flash indicating that your battery is low.
When the battery is out of power the led will flash rapidly and the device will turn off to protect from over discharge.At this time recharge the battery.
Shorted Atomizer/Cartomizer --- If there is ever a problem with your atomizer/cartomizer the device will alert you by displaying a error code on the LED display
Locate the problem or replace the atomizer/cartomizer and the device will resume normal operation.
Error Codes
LOR---Lower resistance indication;If the resistance is below 1.2ohm,the display will show "Low Load".
LOU---Lower voltage indication.If one 18650 battery voltage is below 3.4V or 2 18350 batteries Superposition voltage is below 6.4v,the display will show"Low Voltage".
WSC---Short circuit indication.If cartomizer/atomizer output port short-circuit,the display will show"Warning Short Circuit".
