Sort of new to clearo. Suggestions please

[Blackbeard]

I've been following a thread over on the DIY juice forum that I started about how my eGo-T seems to have mysterious flavor properties. The flavor comes and goes, even on the same tank of juice. Some suggested the Kanger T3 or a Nova to help with the problem.

I've used one of MFS' brand of clearo before and I'm not totally new to them. But MFS is discontinuing them, so I figure they weren't the best of quality. They were OK, but as with any new equipment, there's a learning curve.

The only batteries I have are the ones that came with the eGo-T starter kit (1000 mah), so firstly, if I were to get one of those mini Kanger T3 clearo, which ohm rating should I get to use with my batteries?

I have no intention of starting flame wars, but are the pros and cons of the both mini vivi nova and kanger mini T3 I should be aware of?

Am I just throwing money away by leaning towards the Kanger, and can you all throw your suggestions out as to where I might find the best price and dependability from a dealer?

thanks

 

[bckane]

Hey Blackbeard, I had the same problem with flavors coming and going. I also have the ego-T with a Vision Mini ViVi Nova 2.0
After I started rebuilding my coils the problem seem to go away. I was using 2.8ohm coils............the coils Im building are 2.0 2.2
seems to be much better..........plus I can run my ego-T at 3.8 4 and the battery last much longer. Dont know if this helps

 

[440BB]

If your ego is fixed voltage, it's running at 3.3 volts and will benefit from using the lower resistances. I've found that 1.6 - 1.8 ohm clearos give good results on typical ego batteries. If it is a Twist or Spinner variable voltage, then 2.4 - 2.8 will give you more ability to dial in your favorite voltage.