Squid lost flavor

[cowichanpuffs]

Squid rda had decent flavour with stock assembly. So I figured loosen up this tight draw put in a nano coil qaud twisted 36awg nichrome at 1.0ohm organic cotton 5/64 air hole and it will be tasty as hell. Nope I look like a steam engine but hardly taste my juice.

Any thoughts on how to get the flavor back?

sent from the voop room

 

[cowichanpuffs]

Anybody?

sent from the voop room

 

[classwife]

Moved to Rebuildable Atomizer Systems from The Modding Forum - Atomizer mods

 

[HecticEnergy]

Old post I know...

I have an octopus RDA. A bit quarky for me. I have stock air holes and build 28 ga on 1/16 drill bit at 1.3 ohms. I put it in as a chimney style wick (like a carto). With cotton wrapped around the coil. And that works for me when I can get the atty to fire.. (I have issues with the positive post on mine slipping up into the atty, and off contact with the positive pin in the 510 connection.)

Personally I don't like how little room there is for wick on the deck, or how little of a resivor there is on the octopus. Also the posts are a pain to get tight and keep tight.

I got an Igo w. I put a single 1.3-1.7 ohm coil in there and that seems to do ok. The draw is too wide for me even on the smallest setting. The igo has the posts that you thread your leads into like the octopus/squid, but with 32ga kanthal, a lot of times it will loose connection, because the wire gets cut when you tighten down the screw on the top of the post. Not a problem with 32ga.

I just got a trident RDA clone and LOVE IT! Took a build easily and vapes like a champ with same setup as octopus! A dream to build IMO, and perfect air flow control for me!

Hth




Sent from my iPad using Tapatalk HD

 

[dgarci]

Squid RDA had decent flavour with stock assembly. So I figured loosen up this tight draw put in a nano coil qaud twisted 36awg nichrome at 1.0ohm organic cotton 5/64 air hole and it will be tasty as hell. Nope I look like a steam engine but hardly taste my juice.

Any thoughts on how to get the flavor back?

sent from the voop room

Looks to me Like you might have too much air going in.
If I got it right, you making too much vapor wouLd mean that your juice (fLavor) is dissipated that much more.. so Less fLavor?
how to get the fLavor back? Less air going in.. or, get a smaLLer drip tip maybe?

btw, anyone who knows better.. pLease do correct me if Im wrong. I am definiteLy not a veteran here.

 

[Jimi D.]

Have ya tried Crab juice ? I just had to say it

 

[Rmcgloth]

You could put a piece of aluminum duct ing tape over it and poke a new hole with a needle. 5/64 doesn't seem huge, but with a tiny chamber like that a little makes a big difference. I ran mine up to 1.5mm, and there is a good balance, but that is with a .6 ohm coil, which is a fairly warm vape.