Sudden Juice Level Drop in UFS

[wigglr]

So I fill up my UFS, and I might open the juice control a bit too much which may cause this, but then I close it and vape away. And I barely vape anything before it's dry. The thing is that I really don't have it open that much... maybe 1/4 or 1/8 of a turn and suddenly it drops. For instance, the level of juice may be to the top of the window, and suddenly it is halfway down the window or at the bottom of the window.

Any other causes? Maybe some tips and tricks for the ...... I am

 

[Major]

It may sound silly but I start with the juice control closed and move it to open in very, very small increments. I have found depending on what I am using for an atty that I can go from too little flow to too much flow if I just twist it open to a preset range.

Once I get the right range for it, I leavfe it alone until I refill. Have you looked in your collection tank? I am thinking that is where your juice is going when it hits the "too open" increment.

 

[wigglr]

Funny thing is my collection tank is pretty clean when I go to refill

 

[silentt]

Maybe you are vaping in your sleep..

 

[Para]

Maybe you are vaping in your sleep..

Could be....if it's not in the UFS and not in the collection tank; where else could it be?

 

[wigglr]

I was thinking it went into the collection tank or into the atomizer extension. It just happened again with a refill. I slowly went through the process of opening it a little then draw, opening it a little then draw.... And suddenly BOOM (well not loudly) the juice level dropped and I wasn't sucking anything extra into the atomizer! IT"S A MYSTERYYYYYYYYY lol

 

[utal]

Hi!

in UFS v1 I don't have any issue, however on v2 I still not found the way to go

I use the same juice and same 510LR, CISCO and e-cigz London atomizers on both UFS versions, but somehow I keep having dry hits consistently on v2 and need to do a blow in short times, even with the juice control all opened! With Kanger DC on UFS2 I have a great vape.

Anyone experienced the same and found the correct way to work with it?

Thanks!

 

[thedudeabides]

Open your air control some as well. The more closed the air flow the more suction of juice from the tank to the atty. The juice control is not the only thing that controls juice flow. The air control is just as important when adjusting the suction of juice to the atty. When I'm using a thinner juice, I open my juice control a crack and then adjust air control from there.

 

[wigglr]

Thanks, thedude. I do the same thing -- I find the UFS v2 can get very airy with the air control too far open... so actually the first thing I do is open the air control to the point at which I most prefer.

 

[thedudeabides]

Yeah, I usually start with both closed, crack the juice and air and then adjust air from there for thinner juices. For thicker juices I do the same but open the juice a bit more.

 

[wigglr]

I think slow and steady is doing the trick