Tank Issue - I am always getting burnt Cartomizer

Status
Not open for further replies.

Whoopin

Super Member
ECF Veteran
Verified Member
May 10, 2012
303
60
34
Borderlands
Hey guys!

I am not sure where this goes, but I hope I have come to the right place. I recently got a tank, and I have gotten a doil coil cartomizer along with it. I have managed to punch 2 bigger holes. The following steps are I what I take to fill it up:

- Fill up the tank.
- Drip about 20-30 drops into the cartomizer from the top, until it starts to drip from the connector
- Clean it out
- Let it sit overnight

And the next day, I just take a suck without fire-ing it up for 10-12 times, ensuring that it is wet and I blow the juice out. However, after about an hour, it starts to burn my throat. And then I stop using it. Then I let it rest for a few hours and I when I start vaping again, it burns after a few sucks. Now it just burns whenever I take a drag from it. This has been happening for a 5 of my cartomizers. Am I doing something wrong? By the way, I tried taking a drag then inhaling, or inhaling directly into my lungs, both doesn't seem to work. Could someone provide me some advise for this? Thanks in advance!
 

Whoopin

Super Member
ECF Veteran
Verified Member
May 10, 2012
303
60
34
Borderlands
Photo on 1-7-12 at 5.21 AM.jpg

Here's a picture of the tank. By the way, the DC Cartomizer I am using is flanged, 510. I vape them at 3.0 volts, and it is burnt. Vape at 4.0, even stronger burnt taste and throat burn (it scorches my throat when it burns!). I am using a 50 PG /50 VG juice at 9-10mg nicotine level.

Thanks for the help again in advance! :)
 
Status
Not open for further replies.

Users who are viewing this thread