Looks great, must feel good to have her home!
I thought Face fixed all of the alignment issues with new jigs...???
Mine sucks a ton of juice lately...!
I run 4/5 on mine, conductivity is pretty outstanding and 3/4 ends up too hot for me. Mine came from the vendor, and absolutely no machine oil / other residue in there.
There were two issues with these. Both affected the Con units, only one affected the very first batch through the vendor, both corrected now.
Issue one was with the spring inside of the "electronics port". The one that's in there now is a beast.
The other is the tanks, on the original tanks, the threaded portion of the tank came up too high and covered the topmost o-ring causing a little bit of seeping of juice / condensation from the top cap.
Here's a pic of the new tank on it.. All current units are shipping with both upgrades.
![]()
..........my red dragon tubes were off by 3/8".... all my tubes lined up with each other on the HR, BUT, the atty/tank section did not, it was off by half an inch
.........yea I find that ALL of my thick wick apv's vaporize a crApton of juice....
seriously though, because of the nice and fine threading of Face's work, ya don't have to take much off with careful sanding to bring 'em into alignment. I used an autobody sanding sponge (orange) to do the dirty work
Last edited: