The " Terminator " is now available in 901 and 510 styles

Status
Not open for further replies.

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
The " Terminator " a variable voltage ADD ON for your PV is now available at NOTCIGS.COM

Specs : The "Terminator " is an ADD ON for High Voltage Mods ( 6 volts and above ) It is built into a 901 atomizer tube so it is 1.5" long and .36" in diameter .

It is adjustable via a small adjustment screw from 3 volts to 6 volts ( the upper range depends on the batteries used )

It screws onto your existing device then you attach your atomizer or Carto to it , you can adjust the voltage to get your best vaping voltage .

The Terminator is a NOTCIGS ORIGINAL DESIGN, avoid knockoffs from unscrupulous suppliers!

Specs :


3.0 volt batts = 6.8 volts unloaded
3 ohm load = 5.0 volts out max
2.4 volts min.

3.7 volt batts = 8.3 volts unloaded
6.3 volts Max
2.4 volts min.
3 ohm load
 

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
It does interest me greatly but it isn't cheap:laugh:!

I was wondering if you'd sell ones that were fixed at a certain voltages that aren't covered by most mods, like a 4.3 or 4.4, at a lower price? :unsure:

No these are adjustable from 2.8 volts to 5.5 volts , I dont make fixed ones Sorry !
:D
I have a question and probably a dumb one. I was going to order and I noticed it said for 6+ volts. This won't work on 5 volt mods? Good price, less than a carton of smokes.

They need at least 6.o volts to give you the range, there is a 1+ volt drop across the regulator.
 
Status
Not open for further replies.

Users who are viewing this thread