Tidal Coils on a Vulcan?

[NateHevens]

I can start a thread elsewhere! Yay!

So I have an authentic Vulcan RDA. I'm wondering if I could do tidal coils with this one. Could I do dual, or would I have to do it continuous or just single?

My mod is an authentic Raijin, and I'm using VTC4 batteries. I don't have an ohm reader, but after suggestions on my (re)introduction thread, I'm very likely going to get one tonight.

So will tidal coils fit into the positives and negatives in the Vulcan (without drilling bigger holes, that is... )? And if so, what size wire should I use?

 

[NateHevens]

So... no one, then?

 

[Arystalis]

I would highly suggest in investing in a ohm reader or multi meter. As far as wire goes, .5 flat and 32g wires. You might be able to get one for sure, as for two, might be a tight fit and drilling out wouldn't hurt. Hope this helps.

 

[NateHevens]

I would highly suggest in investing in a ohm reader or multi meter. As far as wire goes, .5 flat and 32g wires. You might be able to get one for sure, as for two, might be a tight fit and drilling out wouldn't hurt. Hope this helps.

I actually did end up getting an ohm reader, so I'm using one now.

.5 flat, 32g wires. Okay. I'm actually trying to do continuous, but I've not done well so far.

It does help. Thanks.

 

[dirzted]

I would say just use 3 strands 32 guage if you really need to do a dual (i have authentic and haven't drilled out holes and that fit fine) as opposed to 5, my primary recommendation is to just do a SINGLE COIL!!! Single coils are soooo much better in the vulcan with how limited the airflow is, and im not saying that for clouds, for flavor, it makes the draw perfect IMO and in that way improves the consistency of the vapor and makes the flavor better, a single tidal wire build is friggin great for that RDA, hope you enjoy it regardless!

 

[NateHevens]

I would say just use 3 strands 32 guage if you really need to do a dual (i have authentic and haven't drilled out holes and that fit fine) as opposed to 5, my primary recommendation is to just do a SINGLE COIL!!! Single coils are soooo much better in the vulcan with how limited the airflow is, and im not saying that for clouds, for flavor, it makes the draw perfect IMO and in that way improves the consistency of the vapor and makes the flavor better, a single tidal wire build is friggin great for that RDA, hope you enjoy it regardless!

I actually got my Vulcan drilled... two holes, on each side, just above the V. The clouds are pretty awesome this way.