Tight Draw on my X2 clearomizers

[saxguy9345]

When I first got them, everything was perfect. Now I'm getting the cement milkshake effect, and I've noticed that I can get a decent vape when I try to "bend" the clearo off the battery while firing. Basically it looks like either the skirt or something on the bottom isnt letting air through. Can you screw the bottom post out of the SI x2 clearos? I tried that, and I notice the clearo is sitting a bit higher from the battery, but I still get the tight draw.

Any ideas?

 

[saxguy9345]

Holy crap, I got it. There are two little holes at the bottom of the battery threads on the X2. I had about 12lbs of cheap napkin stuck in there, likely super-glued with dried out juice. I used a sharp needle to clear em out, back to 100%. 10 min before I was heading out too! So happy. Case closed.

 

[awsum140]

There are also two small holes at the cap end, charger end, of the battery that need attention once in a while. Pocket link can get in them, then the battery won't fire.