Triple twisted 32 ga @ .8 ohm

[KurrptSenate]

if you think triple 32 gauge is good...

you should try .8 flat ribbon kanthal with a piece of 28 gauge kanthal. best flavor I've found for a coil so far (tiger coil)

 

[catmomma]

Hee hee, I've got some flat .8 as well, that will be the next time

 

[VAscooter]

Here's my attempt at the triple wrap. Mine came out .9 and may not be the prettiest but it sure does give out the flavor. Sitting in a Cyclone I got from Chowderhead72 this weekend. Really makes the Virus pop! This was my first attempt at a triple BTW.

 

[Dominique Hoogduin]

quad twisted 0.20 mm on a reo at 0.7 ohms. This stuff is pretty easy to make.. just have to figure out how to stop the wire from flying through the room.. dremel goes a bit fast

 

[VAscooter]

quad twisted 0.20 mm on a reo at 0.7 ohms. This stuff is pretty easy to make.. just have to figure out how to stop the wire from flying through the room.. dremel goes a bit fast

Lol. I'd like to see that. No regular drill available? Whatever works I always say. Never thought of using a Drexel.

 

[Dominique Hoogduin]

Lol. I'd like to see that. No regular drill available? Whatever works I always say. Never thought of using a Drexel.

have a big ... wired drill thats a bit heavy to hold with one hand.. but ill give that a go next time ;} think it turns slower then the dremel with a nice trigger. Just need something to hold the wire on the drill end.. it flies off the hex tool im using

 

[jblindy]

I just put a bit in the end of my cordless and clamp the wire in with the bit. Way easier than the allen wrench method.

 

[itsrayray]

View attachment 342132
Here's my attempt at the triple wrap. Mine came out .9 and may not be the prettiest but it sure does give out the flavor. Sitting in a Cyclone I got from Chowderhead72 this weekend. Really makes the Virus pop! This was my first attempt at a triple BTW.

Those cyclone do not give much room at all lol. I ended up with a dual twist 28 ga 9 wrap that barely fit. Been in there for a few months now. I hardly use it now I have my sub ohm grand, didn't fret drilling out the rm2. Scared to do it on my cyclone lol.

If you all think twisted is awesome try a parallel. I do dual 28 ga, 5 wrap, essentially a 10 wrap 28ga, but at .6 ohm. Really nice.

 

[nube creador]

twisted 26g with 6 wraps on my kayfun is prob my fav build. such good flavor from twisted

 

[VAscooter]

Those cyclone do not give much room at all lol. I ended up with a dual twist 28 ga 9 wrap that barely fit. Been in there for a few months now. I hardly use it now I have my sub ohm grand, didn't fret drilling out the rm2. Scared to do it on my cyclone lol.

If you all think twisted is awesome try a parallel. I do dual 28 ga, 5 wrap, essentially a 10 wrap 28ga, but at .6 ohm. Really nice.

May have to give that a try. No problem for me building dual coil on Cyclone. Had room to spare. I'm going to invest in one of those Hudy allen head drivers though for the screws.

 

[VAscooter]

I swapped out my Reo bottles and replaced the Virus I was using with the new triple twist coil and replaced with my Frenilla/BSP blend. That lasted about 30 minutes. For me, I like the higher ohm coil for that mix. Back to the Virus. It shines with it!

 

[jblindy]

if you think triple 32 gauge is good...

you should try .8 flat ribbon kanthal with a piece of 28 gauge kanthal. best flavor I've found for a coil so far (tiger coil)

If I had some flat ribbon, I'd try it out. But I have none, and I don't see any in my vape shopping cart future. I'd probably never use it for anything.

I did find that the triple twist tastes much better than the quad twist though. As soon as I finish this tank, I'm gonna go back to the triple twist.