Trouble with DCT ><

[Mellow]

So I tossed these to the side for a few months, picked it back up last week and have been having trouble since. I normally fill up my carto then put it in the tank fill it up a bit vape here and there and thing are smooth for maybe a few hours. After that the draw gets harder and harder to get along with vapor, taste etc before it just plugged up. Pulled off a few and cut some slots and then I was flooding it. Ahh the frustration used to love these thing where am I going wrong people, back to dripping for now

 

[tj99959]

Sounds to me like you may be using to low a voltage to drive the coils if you are using DCC's.
Personal opinion of course, but I think dual coil cartos are a complete waste of time. At anything less than 4.5v you are running those coils at about half efficiency.

 

[Mellow]

I use it on my VV box or LT

 

[tj99959]

I use it on my VV box or LT

Ok, the LT will default to about 3.1v because of the amp limiter. (it will still read what you have it set at) This will make them clog almost instantly.
What make box are you using?
On my home made box it starts putting out a fair amount of steam at 4.5v, and is a pretty heavy hitter at 5v. But, that is 3.3amps and 16watts you are asking the PV to put out. (8watts to each coil)

 

[Mellow]

I normally am right around 4.5-4.8 v Its a Splah Mod takes 2 IMR 18650's, I have a voltage indicator and it does drop on the LT but only about.1 For example it says its at 4.7 and will actually run at 4.6. Sugguestions are welcomed also its a 1.5 ohm DC

 

[Mellow]

Actually got one up an running well for its 3rd day now, not sure if it just a crap shoot with these cartos or what