By the way, do you ever do this to get a little more life out of a carto whose filler material is pretty gunked up from thick or dark juices? Tracker II
No. When the pfill starts to get "thick" it's a sign the Carto need to be rinsed out. All the sugar is building up and carmelizing in the filler....but soaking it in Vodka and flushing it in hot water will take care of that quite quickly. I actually avoid dark juices since they tend to not be Carto friendly. (sucks cuz there are some dark juice flavors I like ) If you are staying with same flavors and just want renewed performance out of those cartos watch the video below. It will show how to give those a Carto a quick rinsing.
I just happen to blow the inside of my cart out with my air compressor today while cleaning carts and tried it,very good. Traveling Man
I managed one on first try, tweezers only, no needle, came out in one fell swoop! Kittypie
It's a 50/50 shot Kittypie, if the wicking material comes up with pfill it's game over. You can use 1 leg of the tweezer, pressing the pfill against the inner housing and move it back and forth to help loosen the pfill. I think I mentioned that I have on occasion just yanked the filling out leaving the wicking material and tube intact.
Snow, sir ...... in your video, you stated "8 to 10 draws, from 2 or 3 drops". So may I ask if that would be the same for normal dripping? (a non-surgically-altered carto) On average, I should get about 4 or 5 draws per drop? Wintering
Well, dripping is the purest of the pure so-to-speak, max flavor is the driving point. I can't speak for every atty or PV set-up, but from my experience it's about double that. Strong flavors are the best indicators like a menthol or something are best to detect when the flavor has peaked to determine your Drop/Draw ratio.
I first tried this trick after reading the thread "Dogs' NF Carto Mod (KR8 Atty)(510 verticalatty)". I did experience leakage so be careful! Lambolover808
Lambo I'm curious when you caution about leakage...do you mean leaking from the bottom of the Carto, out the wick tube/post hole on the Carto Connector, or out of the mouth piece if the Carto is tilted downward?
I ask because the base of the Carto is a pressed fitting with 3/16" wall as well the metal air/wick tube which extend up from the base of the Carto is a 1/2" long. So if you are dripping 6 drops at a time (3 in Carto and 3 on the Wick Tube) it should never be enough to go above the metal air/wick tube. But if you drip into the Carto, then turn it upside down or hold it with LED end of your battery higher than the Carto it will indeed leak out of the rubber mouth piece cap.
Here is a pick of the Carto Base:
Vapor4life Tips, Tricks & Fixes for Cartomizers - YouTube (4:30 mark)
I'm always amazed at how much vapor this produces and how fresh the juice tastes. However the Cartos themselves only last a week or so as the Atomizer starts to clog up. I have never tried to wash them out afterwards since I only do this mod on cleaned used Cartos.
Being a full time dripper means carrying juice with you all day, that's just too much commitment for me personally.