*Update to is it safe*

[jmkdta]

I got a bunch of different screws for a new center pin but none of them work the deck is still lose. Blows my mind, no pun intended!

SO i took the dremel to the 510 threads. The taifun isn't that dirty I think my lens is. its an old phone. I tested the rta with a volt meter and no continuity between the center pin and 510 or body. I guess that means its safe for a hybrid right?

 

[zoiDman]

Good Job cutting down those threads.

And yes... If you have No Coil mounted, you shouldn't have any continuity from the Center Pin to the 510 Thread/Atty Body.

 

[jmkdta]

Good Job cutting down those threads.

And yes... If you have No Coil mounted, you shouldn't have any continuity from the Center Pin to the 510 Thread/Atty Body.

Thank you! I will probably throw a build on it tomorrow and see how it does!

 

[zoiDman]

Cool.

Let us know how it works.

 

[UncLeJunkLe]

Even though you tested for non-continuity, won't hurt to ream it out one more time with a small, fine file for good measure. Then clean it really well.

I'd also put an insulator of sorts around that head, between the head and the inside of the 510. But you do you.

 

[jmkdta]

Even though you tested for non-continuity, won't hurt to ream it out one more time with a small, fine file for good measure. Then clean it really well.

I'd also put an insulator of sorts around that head, between the head and the inside of the 510. But you do you.

I was thinking the same thing. Not sure what I could use for insulator other than an o-ring

 

[UncLeJunkLe]

I was thinking the same thing. Not sure what I could use for insulator other than an o-ring

Nothing wrong with using an oring as an insulator, or 2 beside each other if needed. You could also use a small piece of tubing. Really anything that will fit snug and insulate the pos from the negative.

 

[boo2600]

Looks safe...