upgrading, need advice

[bmf4069]

So I've been vaping for about a month now on an eGo, half that with a PT3v2. I went to my local store and took a few puffs of on of their box mods; a Hana clone I believe. Well, I fell in love. I vaped awesome with the Atlantis and even the 6mg juice felt good.

So I've been looking at the sigelei 100w+ with efest 20/35A batteries and a charger from eciggity. I don't wanna spring for an aspire just yet so can I just build a 1 ohm coil (or dual 2 ohm) for my PT3? And is the sigelei 100w+ a good choice? I eventually wanna try an RDA with some high VG and blow some clouds too.

On a side note, can an eGo handle a 1 ohm load?

 

[williamclarkonet]

So I've been vaping for about a month now on an eGo, half that with a PT3v2. I went to my local store and took a few puffs of on of their box mods; a Hana clone I believe. Well, I fell in love. I vaped awesome with the Atlantis and even the 6mg juice felt good.

So I've been looking at the sigelei 100w+ with efest 20/35A batteries and a charger from eciggity. I don't wanna spring for an aspire just yet so can I just build a 1 ohm coil (or dual 2 ohm) for my PT3? And is the sigelei 100w+ a good choice? I eventually wanna try an RDA with some high VG and blow some clouds too.

On a side note, can an eGo handle a 1 ohm load?

I would get a VAMO V6 or iStick

 

[bmf4069]

One of the reasons I wanted the box mod was for battery life too.

 

[danmn1313]

I love my Sigelei, I came from a Vamo because I needed more power.

I tried my Aerotank Mega on it and just got bland flavor at 10 watts, if I turned it up more I was getting dry hits. This was on a fresh 1.5OHM coil. With my Aspire I can vape it fine up to 18 watts or so.

This mod really shines when you get yours RBAs on there, flavor, vapor, and battery ferrrrrdayyyyzzzz!

 

[Susan~S]

1. The Sigelei 100w+ requires 30A batteries. The Efest are only 20A CDR.
2. Yes you could build a 1 ohm dual coil for your PT3 but you can't use it on an ego. Most ego's have a 2A limitation. 1.8 ohm is about the lowest you should build an a fixed voltage ego.
3. Without airflow control a 1ohm coil on a PT3 might not work very well.