user friendly quad coil rba

[gt58]

ive been looking around online for some nice rba that supports quad coils. im currently on an igo w and yes, quad coils are possible but ive been looking around and ive stumbled across the helios that is a triple post but the positive supports 2 holes for easy quad coils. im looking for the "next step" from the generic igo w's and nimbus clones out there.

any suggestions? not trying to spend a fortune either on some 24 karat gold plated something or another haha under $150ish i think should suffice. thanks!

 

[VictorViper]

No personal experience from me here (yet), but I'm patiently awaiting the arrival of the Helios dripper. Has airflow control, two negative terminals and, uniquely, a positive terminal with two separate holes. Well under your $150 limit, too. Check it out.

[EDIT] I'm not sure how I missed you mention the Helios in your post... yes, look at that one.

 

[Raycecar]

The Helios and GV Trident are great for quad coils.

 

[Exhaler]

I was not looking for a quad just a 2 banger and went with the Helios. Yes it sure will take 4 but I probably will stay with two. I spent a whole day looking at opinions of drippers and prices. Looking for good construction and air flow. If I wanted looks the VA Cyclops with VA cap and dripper would have won out, pure eye candy, but a bit smallish for me also.

 

[JD1]

ive been looking around online for some nice rba that supports quad coils. im currently on an igo w and yes, quad coils are possible but ive been looking around and ive stumbled across the helios that is a triple post but the positive supports 2 holes for easy quad coils. im looking for the "next step" from the generic igo w's and nimbus clones out there.

any suggestions? not trying to spend a fortune either on some 24 karat gold plated something or another haha under $150ish i think should suffice. thanks!

Have you tried duel wire wraps for each coil. I only have 32 ga. at the moment so I use that all the time to get down in the 1.4 ohm range and keep my wrap count up for good wick coverage. Just fold a piece of wire in half and wrap the two wires side by side and tight as possible. Here's a picture of a single coil duel wire setup. Just build a couple of these for your w. It may not work out but it's easy to do and should be worth a try at least. 2nd picture. http://www.e-cigarette-forum.com/fo...ncrease-vapor-flavor-th-667.html#post10892346

 

[gokusnimbus]

innvape patriot

key features:
functional heat sink
3 posts
factory drilled 1.8 mm air holes
roomy chamber for all types of builds

its practically ready to dual/quad/etc