Whic is the Best RBA for Dual or Quad Coils sold by Reos Mods?

[niczgreat]

Hi All,
Went to Robs site and saw all these new rba's including a modded IGO-W
So which is the best RBA on The Reos Mods website.

I have a LP Reo and am going to do dual coils or maybe even Quad coils if the RBA supports it.!

I'm willing to drill bigger holes in the sides to handle the heat.

I think I tried an Igo-w for dripping in the past and really liked it.

Currently using a Reomizer 2 in dual coil configuration. Ho Hum...

 

[JetMac]

I don't know about quad coils cause I've never tried them, however for dual coils the RM5 is probably my favorite. Very airy, it has awesome flavor, and produces enough heat and vapor to keep me happy. The RM6 is a little bigger than the RM5, has a little more room on the deck for coils. Has very good AFC, personally I think the RM5 has better flavor, and they both have a good amount of vapor. One thing about the RM5 vs the 6, the 5 has slots in the posts for ribbon or bigger gauge wire where as the 6 just has holes in the posts and you could probably stuff dual 24g thru them at the most.


Sent from my iPad using Tapatalk

 

[Doffy]

i like the rm3 but i'm a compact attie guy

the reomizer 6 is good for quad coils, just watch you don't go too low on resistance

the reomizer 5 is ok if you are going to leave the afc wide open, the "A" in its afc should be "f" for fixed cos it is either wide open or sealed off and doesn't hold in between well

the reomizer 4 is 19mm and good for duals

 

[TraceyS]

I like the RM3! I have two that stay on my two REO's. Dual coil builds, very friendly atty. I have the RM4 someone loaned me but it is too airy for me.

Tracey

 

[niczgreat]

Wish me luck, I decided to go with what I know.

I used to use a Igo W with a top feeder and it was my favorite, so I bought the BF modded version from Reos Mods.
He lowered the price from $42.00 to $35.00 and that was the trigger. The Igo W is available so cheaply, it was hard
to justify paying that much. But I was paying for Robs Expertise! I know that Rob does quality modding so the RBA should be good.

I'm just hoping that it'll fit my new GreyScano 50

 

[Train2]

For additional variety in bottom-feed atties, you can also check out Catfish Atty Mods, you can search here for Catfish or Chowderhead - he bottom-feeds all the "hot" atomizers, some legit and some good clones. So you could get a Derringer or a Rogue or a Marquis, etc. Not sure what's best for quads, but there's a selection...

Wish me luck, I decided to go with what I know.

I used to use a Igo W with a top feeder and it was my favorite, so I bought the BF modded version from Reos Mods.
He lowered the price from $42.00 to $35.00 and that was the trigger. The Igo W is available so cheaply, it was hard
to justify paying that much. But I was paying for Robs Expertise! I know that Rob does quality modding so the RBA should be good.

I'm just hoping that it'll fit my new GreyScano 50