Using Vodka for clean out?

[Countrypami]

Hey ya'll

I've never used vodka to clean my carto's before. Can someone tell me exactly what to do?... do I just fill them with vodka?... how long do I leave it in there?... Do I vape to pull it into the atomizer??

Thanks
Pami

 

[c1truz]

Doesn't answer your question but i just boil mine for about 15 mins. Rinse, repeat until the steam no longer smells like juice. Works fine for me.

 

[Ref Minor]

+1 for boiling.

 

[brock957]

I put vodka in a glass. Take the tank apart. Put everything but the plastic tank part in the vodka. After all night or a few hours take it out dab dry with a paper towel. Let sit for a hour. Put back together fill and vape. Some people run hot water over after removing from vodka and dry. Works good for me.

 

[clstearns]

Generally, I use everclear rather than vodka, but either will work. I've found two ways that work well:

1. Drip five or six drops into the atty while holding it in a paper towel, let it soak for a few seconds, and then flip it and blow through the threaded end; repeat until the liquid comes out clean; or,

2. Pour a shot or so into a glass (enough to cover your atomizers) and let them soak anywhere from twenty minutes to overnight, then remove them from the liquid and let them dry completely.

I've found both of these methods to work, even if I've "burned" the atomizer. As long as the coil is still intact, obviously.

Hope this helps!