vape 7 and isotope mod questions.

[synical]

Sorry if this is posted in the wrong thread. Mods please move to correct place if needed.

I was out of town a couple of months ago and my main mod broke. I purchased a vape 7 mod and it was working fine earlier but over time it would stop. I noticed the bottom button would slightly turn every time I pushed it. I played with both top and button connectors (adjusting, using plumbers tape) but would become loose or not connect. Any tips to get this working properly? It gets annoying to trying to adjust it after "X" times.

Also, the mod that broke was the glass for my "isotope" mod. I've contacted various local stores and an online supplier that sold the mod. Anyone have an idea where to get the replacement glass for it? I've been vaping for 3 1/2 years and this has been my favorite mod of all that i own.

Thanks in advance.

 

[nynvolt]

If the bottom pin is one of the slotted screw type, you can add a little O ring or a tiny lock washer. Crank it tight and only adjust for battery rattle with the top pin.

Hope that helps. Sorry I'm not familiar with the isotope mod.