How do these work?
Just some crazy old lady happily vaping away.
These are called Cartomizer Tank, basically you just insert a cartomizer to the tank, fill the juice, and put on a 510 drip tip, then you are ready to vape

, there are nothing much to say about the tank it self, it just top bottom cap, and the glass, but different will be the quality, the top and bottom cap the Flathead we selling is made by lightweight alum, and glass is a thick pyrex glass, and is local US made.
So what is a cartomizer? is a tube like metal piece that either you can just vape it directly (if no hole punch) or insert into a tank (must punch 1 -2 holes in order for liquid to absorbs, or get the cartomizers with pre punched hole), inside the cartomizer is that wrapped in a roll of polyfill material which absorbs the e-liquid, it can be single coil or dual coil, either way, you will need to prime a cartomizer before it can be use, there are many ways to prime a cartomizer, youtube is a good way to do some research on it, basically you just keep dropping juice in the polyfill material, until the whole tube is wet and absorbs well, but over dripping can cause flooding as well, a couple times of trial and error, then you can easily master it.
There are many reasons to vape a cartomizer tank over a clearomizer tank, you can get much warmer vape over clearomizer like Protank, and cartomizer tank usually with have larger capacity, well, some people just like the look of a cartomizer tank.
Also usually there are 2 sizes, 45mm and 35mm, depends on the tank you using.
Below are the cartomizers that we selling, they all come with pre punched holes as well.
cartomizer
I hope these information can help you out a bit about cartomizer or collect me if i said anything wrong
